Differences between revisions 1 and 17 (spanning 16 versions)
⇤ ← Revision 1 as of 2007-02-27 16:40:29 →
Size: 1593
Editor: BartVandenbussche
Comment:
← Revision 17 as of 2007-03-12 20:36:28 → ⇥
Size: 6879
Editor: PierreRoyer
Comment:
Deletions are marked like this. Additions are marked like this.
Line 1: Line 1:
= Filter Wheel control loop procedures = #pragma section-numbers on
Line 3: Line 3:
#pragma section-numbers on = Filter Wheel control loop procedures =
Line 9: Line 9:
= Treshold parameter optimisation Photometer filter wheel = = Threshold Tuning =
Line 11: Line 11:
|| Script || TCL || Parameters || Comments || 
|| PACS_Phot_HK_Setup_OBS || || || ||
|| PACS_Phot_Fil_Diaghk_Setup_OBS || || || ||
|| PACS_Phot_Fil_ParameterLoop_OBS || || || ||
|| PACS_Diaghk_Reset_OBS || || || || 
|| PACS_SAFE_MODE.tcl || || || || 		 == Threshold parameter optimisation Photometer filter wheel ==

A loop over steps 3 & 4 can be implemented for a number of thresholds

|| || Script || TCL || Parameters || Comments ||
|| 1 || PACS_Phot_HK_Setup_OBS || || || ||
|| 2 || PACS_Phot_Fil_Diaghk_Setup_OBS || || || ||
|| 3 || CONF_phot_fltw_param_OBS || Yes || rate,drive_current,threshold || ||
|| 4 || PACS_Phot_Fil_nturns_OBS        || Yes || nturns : number of full turns of the FW || ||
|| 5 || PACS_Diaghk_Reset_OBS || || || ||
|| 6 || PACS_SAFE_MODE.tcl || || || ||
Line 19: Line 24:
= Treshold parameter optimisation Spectrometer filter wheel =  == Threshold parameter optimisation Spectrometer filter wheel ==
Line 21: Line 26:
|| Script || TCL || Parameters || Comments ||
|| PACS_Spec_HK_Setup_OBS || || || ||
|| PACS_Spec_Fil_Diaghk_Setup_OBS || || || ||
|| PACS_Spec_Fil_ParameterLoop_OBS || || || ||
|| PACS_Diaghk_Reset_OBS || || || ||
|| PACS_SAFE_MODE.tcl || || || || 		A loop over steps 3 & 4 can be implemented for a number of thresholds

|| || Script || TCL || Parameters || Comments ||
|| 1 || PACS_Spec_HK_Setup_OBS || || || ||
|| 2 || PACS_Spec_Fil_Diaghk_Setup_OBS || || || ||
|| 3 || CONF_spec_fltw_param_OBS || Yes || rate,drive_current,threshold || ||
|| 4 || PACS_Spec_Fil_nturns_OBS || Yes || nturns : number of full turns of the FW || ||
|| 5 || PACS_Diaghk_Reset_OBS || || || ||
|| 6 || PACS_SAFE_MODE.tcl || || || ||

= Current loop =

Loop over current from 10 to 100mA by steps of 10. For each setting, performs nturns *OPEN LOOP* movements of 360 degrees (default = 3). Open loop movement means that the wheel is driven for a given time, depending on the size of the movement and the rate. Consequently, the movement might finally not be of the expected size.

== Photometer filter wheel ==

|| || Script || TCL || Parameters || Comments ||
|| 1 || PACS_Phot_HK_Setup_OBS || || || ||
|| 2 || PACS_Phot_Fil_Diaghk_Setup_OBS || || || ||
|| 3 || CONF_phot_fltw_param_OBS || Yes || rate,drive_current,threshold || ||
|| 4 || PACS_Phot_Fil_Current_Loop_OBS || No || nturns : #turns of the FW/current setting || ||
|| 5 || PACS_Diaghk_Reset_OBS || || || ||
|| 6 || PACS_SAFE_MODE.tcl || || || ||

= Tuning the rate =

The following test aims at checking the feasability and behaviour stability of the FWs operated at higher rates (= higher speed). The baseline rate = 100, corresponding to an angular speed of 360 degrees in 18.75 seconds.

== Photometer filter wheel ==

|| || Script || TCL || Parameters || Comments ||
|| 1 || PACS_Phot_HK_Setup_OBS || || || ||
|| 2 || PACS_Phot_Fil_Diaghk_Setup_OBS || || || ||
|| 3 || CONF_phot_fltw_param_OBS || Yes || rate,drive_current,threshold || ||
|| 4 || PACS_Phot_Fil_nturns_OBS || Yes || nturns : #turns of the FW || ||
|| 5 || PACS_Diaghk_Reset_OBS || || || ||
|| 6 || PACS_SAFE_MODE.tcl || || || ||

= Influence of disconnecting redundant connector =

The following procedure may be applied w/ or w/o short circuit connector.

|| || Script || TCL || Parameters || Comments ||
|| 1 || Disconnect redundant (connector open) || || || ||
|| 2 || PACS_switch_on.tcl || Yes || || ||
|| 3 || PACS_Phot_HK_Setup_OBS || || || ||
|| 4 || PACS_Phot_Fil_Diaghk_Setup_OBS || || || ||
|| 5 || CONF_phot_fltw_param_OBS || Yes || rate 100,drive_current 4096,threshold 2000 || ||
|| 6 || PACS_Phot_Fil_nturns_OBS || Yes || nturns : 6 || 437 sec ||
|| 7 || PACS_Phot_Fil_nturns_twodirections_OBS|| Yes || num_repeats=2, num_turns=3, slew_time=15|| 981 sec ||
|| 8 || PACS_Phot_Fil_nturns_finepos_OBS || Yes || nturns=2 || 1484 sec ||
|| 9 || CONF_phot_fltw_param_OBS || Yes || rate=200,drive_current 4096,threshold 2000 || ||
||10 || PACS_Phot_Fil_nturns_twodirections_OBS|| Yes || num_repeats=2, num_turns=3, slew_time=30|| 1716 sec ||
||11 || PACS_Diaghk_Reset_OBS || || || ||
||12 || PACS_Spec_HK_Setup_OBS || || || ||
||13 || PACS_Spec_Fil_Diaghk_Setup_OBS || || || ||
||14 || CONF_spec_fltw_param_OBS || Yes || rate 100,drive_current 4096,threshold 2000 || ||
||15 || PACS_Spec_Fil_nturns_OBS || Yes || nturns : 6 || 437 sec ||
||16 || PACS_Spec_Fil_nturns_twodirections_OBS|| Yes || num_repeats=2, num_turns=3, slew_time=15|| 918 sec ||
||17 || PACS_Spec_Fil_nturns_finepos_OBS || Yes || nturns=2 || 1484 sec ||
||18 || CONF_Spec_fltw_param_OBS || Yes || rate=200,drive_current 4096,threshold 2000 || ||
||19 || PACS_Spec_Fil_nturns_twodirections_OBS|| Yes || num_repeats=2, num_turns=3, slew_time=30|| 1716 sec ||
||20 || PACS_Diaghk_Reset_OBS || || || ||
||21 || PACS_switch_off.tcl || || || ||

1. Filter Wheel control loop procedures

2. Conditions

All tests described can be executed from SAFE MODE of from SPECTROSCOPY.

3. Threshold Tuning

3.1. Threshold parameter optimisation Photometer filter wheel

A loop over steps 3 & 4 can be implemented for a number of thresholds

Script

TCL

Parameters

Comments

1

PACS_Phot_HK_Setup_OBS

2

PACS_Phot_Fil_Diaghk_Setup_OBS

3

CONF_phot_fltw_param_OBS

Yes

rate,drive_current,threshold

4

PACS_Phot_Fil_nturns_OBS

Yes

nturns : number of full turns of the FW

5

PACS_Diaghk_Reset_OBS

6

PACS_SAFE_MODE.tcl

3.2. Threshold parameter optimisation Spectrometer filter wheel

A loop over steps 3 & 4 can be implemented for a number of thresholds

Script

TCL

Parameters

Comments

1

PACS_Spec_HK_Setup_OBS

2

PACS_Spec_Fil_Diaghk_Setup_OBS

3

CONF_spec_fltw_param_OBS

Yes

rate,drive_current,threshold

4

PACS_Spec_Fil_nturns_OBS

Yes

nturns : number of full turns of the FW

5

PACS_Diaghk_Reset_OBS

6

PACS_SAFE_MODE.tcl

4. Current loop

Loop over current from 10 to 100mA by steps of 10. For each setting, performs nturns *OPEN LOOP* movements of 360 degrees (default = 3). Open loop movement means that the wheel is driven for a given time, depending on the size of the movement and the rate. Consequently, the movement might finally not be of the expected size.

4.1. Photometer filter wheel

Script

TCL

Parameters

Comments

1

PACS_Phot_HK_Setup_OBS

2

PACS_Phot_Fil_Diaghk_Setup_OBS

3

CONF_phot_fltw_param_OBS

Yes

rate,drive_current,threshold

4

PACS_Phot_Fil_Current_Loop_OBS

No

nturns : #turns of the FW/current setting

5

PACS_Diaghk_Reset_OBS

6

PACS_SAFE_MODE.tcl

5. Tuning the rate

The following test aims at checking the feasability and behaviour stability of the FWs operated at higher rates (= higher speed). The baseline rate = 100, corresponding to an angular speed of 360 degrees in 18.75 seconds.

5.1. Photometer filter wheel

Script

TCL

Parameters

Comments

1

PACS_Phot_HK_Setup_OBS

2

PACS_Phot_Fil_Diaghk_Setup_OBS

3

CONF_phot_fltw_param_OBS

Yes

rate,drive_current,threshold

4

PACS_Phot_Fil_nturns_OBS

Yes

nturns : #turns of the FW

5

PACS_Diaghk_Reset_OBS

6

PACS_SAFE_MODE.tcl

6. Influence of disconnecting redundant connector

The following procedure may be applied w/ or w/o short circuit connector.

Script

TCL

Parameters

Comments

1

Disconnect redundant (connector open)

2

PACS_switch_on.tcl

Yes

3

PACS_Phot_HK_Setup_OBS

4

PACS_Phot_Fil_Diaghk_Setup_OBS

5

CONF_phot_fltw_param_OBS

Yes

rate 100,drive_current 4096,threshold 2000

6

PACS_Phot_Fil_nturns_OBS

Yes

nturns : 6

437 sec

7

PACS_Phot_Fil_nturns_twodirections_OBS

Yes

num_repeats=2, num_turns=3, slew_time=15

981 sec

8

PACS_Phot_Fil_nturns_finepos_OBS

Yes

nturns=2

1484 sec

9

CONF_phot_fltw_param_OBS

Yes

rate=200,drive_current 4096,threshold 2000

10

PACS_Phot_Fil_nturns_twodirections_OBS

Yes

num_repeats=2, num_turns=3, slew_time=30

1716 sec

11

PACS_Diaghk_Reset_OBS

12

PACS_Spec_HK_Setup_OBS

13

PACS_Spec_Fil_Diaghk_Setup_OBS

14

CONF_spec_fltw_param_OBS

Yes

rate 100,drive_current 4096,threshold 2000

15

PACS_Spec_Fil_nturns_OBS

Yes

nturns : 6

437 sec

16

PACS_Spec_Fil_nturns_twodirections_OBS

Yes

num_repeats=2, num_turns=3, slew_time=15

918 sec

17

PACS_Spec_Fil_nturns_finepos_OBS

Yes

nturns=2

1484 sec

18

CONF_Spec_fltw_param_OBS

Yes

rate=200,drive_current 4096,threshold 2000

19

PACS_Spec_Fil_nturns_twodirections_OBS

Yes

num_repeats=2, num_turns=3, slew_time=30

1716 sec

20

PACS_Diaghk_Reset_OBS

21

PACS_switch_off.tcl

Herschel: FmIltProc/FwControlloop (last edited 2009-07-15 14:32:36 by localhost)