1371
Comment:
|
← Revision 4 as of 2009-07-15 14:32:38 ⇥
1384
converted to 1.6 markup
|
Deletions are marked like this. | Additions are marked like this. |
Line 1: | Line 1: |
= PACS_Choppe_AutoOpt = | = PACS_Chopper_AutoOpt = |
Line 3: | Line 3: |
This is the top level module for PacsEng_Chopper_AutoOpt. | This is the top level module for P''''''acsEng_Chopper_A''''''utoOpt. |
PACS_Chopper_AutoOpt
This is the top level module for PacsEng_Chopper_AutoOpt.
// Purpose : Check a series of different chopper controller settings by // chopping between +/- 12000 units (~4 deg) // // Author : Markus Nielbock/Helmut Dannerbauer // CUS author : MN/HD // // Description : The instrumental command for move chopper to absolute position // is called. Go to chopper position +-12000 with plateau time // of 2 sec and chop cycles of 10. // // Dependencies : // // Preconditions: PACS switched on and Chopper switched off. // // Comments : This script is based on the commanding script // PACS_Chopper_uk_move_12000_OBS.cus // // Version : 1.0 // // History : 1.0 20-Nov-2007 (MN) Script to do simple chopper cycle // // // Initialise input parameters: // Defines control parameter range, loops run from k(p,i,c,f)min to // k(p,i,c,f)max defining the inverse of the ratio of parameter change w.r.t. // the default value.
Input variable(s):
procedure PACS_Chopper_AutoOpt { int kpmin = 0 in [-3,3]; int kpmax = 0 in [-3,3]; int kimin = 0 in [-3,3]; int kimax = 0 in [-3,3]; int kcmin = 0 in [-3,3]; int kcmax = 0 in [-3,3]; int kfmin = 0 in [-3,3]; int kfmax = 0 in [-3,3]; }{