#pragma section-numbers on

= Synchronization of Grating, Chopper & Readouts =

The test just consists in operating the wavelength switching OBCP for a few minutes

Note : If possible, as soon as possible, replace steps 1 - 4 by SetupSpectroscopy_OBS

||   || Script                              || TCL || Parameters                              || Comments || Duration [sec] ||
|| 1 || PACS_Spec_HK_Setup_OBS             ||     ||                                         || Sets HK List to SPEC BOTH || ||
|| 2 || CONF_grating_OBS                   ||     || FMILTFast                               ||  ||  ||
|| 3 || CONF_chopper_OBS                   ||     || TBD                                     || TBVerified: Is this Script OK, which parameters should be used ?||  ||
|| 4 || PACS_GeGa_SFT_Init_Cold_He2_OBS    ||     || default                                 || Swon & setup CREs ||  ||
|| 5 || SPEC_CRE_setup_OBS                 ||     || default                                 || CRE Setup ||  ||
|| 6 || SPEC_spu_setup_OBS                 ||     || default                                 || SPU Setup & Science Dataflow ||  ||
|| 7 || OBCP_spec_freq_switch_OBS          ||     || P1=25 P2=1000 P3=1 P4=600000 P5=3 P6=600800 P7=599200 P8=P10=1 P9=-23382 P11=22347 || Wavelength switching || 374 ||
|| 8 || SPEC_spu_reset_OBS                 ||     ||                                         ||  ||  ||
|| 9 || PACS_SAFE_MODE.tcl                 ||     ||                                         ||  ||  ||