1135
Comment:
|
← Revision 7 as of 2009-07-15 14:32:36 ⇥
1206
converted to 1.6 markup
|
Deletions are marked like this. | Additions are marked like this. |
Line 5: | Line 5: |
= Performance Test = | == Performance Test == |
Line 9: | Line 9: |
NB start from spectroscopy mode. '''Both CS must be ON'''. Grating & FW in place |
|
Line 10: | Line 14: |
|| 1 || PACS_Spec_Flashheat_Diaghk_Setup_OBS || || || || | || 1 || PACS_Spec_FlashHeat_Diaghk_Setup_OBS || || || || |
Line 12: | Line 16: |
|| 3 || PACS_Spec_Flash_PFT_low || || || || || 4 || PACS_Spec_Flash_PFT_high || || || || |
|| 3 || PACS_Spec_Flash_PFT_low || || || 4347 sec || || 4 || PACS_Spec_Flash_PFT_high || || || 1699 sec || |
Line 17: | Line 21: |
= IST Test = |
1. Flasher Test Procedures
1.1. Performance Test
Loops over small currents, from 0.1 to 2.0 mA, cheching the flux steps on both CS + determining the saturation level for all pixels.
NB start from spectroscopy mode. Both CS must be ON. Grating & FW in place
|
Script |
TCL |
Parameters |
Comments |
1 |
PACS_Spec_FlashHeat_Diaghk_Setup_OBS |
|
|
|
2 |
SPEC_spu_setup_OBS |
|
|
|
3 |
PACS_Spec_Flash_PFT_low |
|
|
4347 sec |
4 |
PACS_Spec_Flash_PFT_high |
|
|
1699 sec |
5 |
SPEC_spu_reset_OBS |
|
|
|
6 |
PACS_Diaghk_Reset_OBS |
|
|
|
7 |
PACS_SAFE_MODE.tcl |
|
|
|